You should be alert to hold relax roll forming machine to the top of the nut begins. To do this, you need a place to match the guard bolts to 3/8 inch drive ratchet socket. Mention should be vigilant in order to remove it from the top of the Roll Forming Machine.

To remove metal shavings and any debris that might be in the rolls, you should blow the area between the rolls using an air hose. You should also spray the rolls with cool air and lubrication. This is to prevent the rolls from corroding.

Once everything is in place you should slide the guard back over the studs and tighten the bolts that you had loosened. You should inspect the guard and ensure that no part of the guard falls into the feed area of the Howick Style Truss Forming Machine.

You should now start the machine and slide the side of the metal (that you want to roll) towards the starting guide. You should continue supporting the metal sheet as its being grabbed by the Seaming Roof Panel Roll Forming Machine.

When metal is rolled up and pop-up on the other side, you should check to make sure the gap is correct. If the joints malformed or stuck, rolls should be adjusted.For moreinformation, pleasevisit:rollformingmachinerychina.com